CANFORD VIDEO DISTRIBUTION AMPLIFIER
Housed in the standard Canford extruded box with protective ABS bezels, the unit accepts a standard 1Vp/p video signal on a BNC connector (75 ohm termination). A parallel unbuffered input connector is provided, which can be used for looping through to another piece of unterminated equipment.
The amplifier provides 5 outputs on front-panel BNC connectors. A single 16 position switch allows control of the gain and equalisation applied to the signal: each step provides correction for approx. 25m of standard VCS (BBC PSF1/3) type cable, with a maximum correction capacity of approx 375m. This method of equalisation control enables approximate setting without reference to a waveform monitor; simply measure the length of unequalised cable, divide by 25 and dial up the result on the switch. A setting of zero gives unity gain and flat response.
An on/off switch is provided on the front panel, and a green Power LED flashes to indicate low supply voltage. Power is derived from an internal Alkaline PP3-size battery, or an external power supply can be plugged into the rear connector.
Technical Specification:
Bandwidth: |
>20MHz |
Differential gain: |
<0.6% |
Differential phase: |
<0.6% |
Noise: |
-70dB |
Gain/EQ: |
Min: 0dB gain, flat response |
|
Max: equates to loss in approx 375m of VCS (BBC PSF1/3) |
Power: |
Alkaline PP3-size battery, life approx 8 hours |
|
External 6-12V DC 40-60mA supply on 2.1mm jack (centre pin positive). |
Dimension: |
94 × 51 × 123mm |
Weight: |
360g including battery. |